Jumo 705021 mTRON T - Analog Input Module, 8-Ch. Operat Manual de usuario descargar pdf (Pagina 31)

6 Configuration

6.1 Digital selector

The digital selector contains all digital signals that are available in the analog input module 8-

channel to configure the following functions.

• Alarm suppression (see Chapter 6.2.1 "Alarms", page 34)

• Signal suppression (see Chapter 6.3 "Digital input", page 38)

The following table lists all digital signals. The entry in the "Type" column indicates the source

of the signal:

• Internal: Internal signal of the analog input module 8-channel (including the signal of the dig-

ital input)The signal is also transmitted to the base unit via the system bus, to allow it to be

used by other modules.

• External: External input (NV_...) that must be linked in the NV connecting list to a signal

from another module (see Chapter 6.4 "NV connecting list", page 40).

The signal name "NV_..." indicates the intended use; in principle, the signal can also be

used for other purposes.

Alarm

The collective alarm of the analog input module 8-channel is made up of all functions for which

the "Collective alarm" alarm type has been activated.

TIP!

The parameters described in this section can be configured either with the setup program or

on the multifunction panel.

Category Signal Type Description

Inactive No signal selected

Analog inputs AI01Alarm1 to AI08Alarm1 Internal Alarm signal 1 of analog input 1 to

AI01Alarm2 to AI08Alarm2 Internal Alarm signal 2 of analog input 1 to

Digital inputs DI01 Internal Signal of digital input

Signal rejections NV_SR01 to NV_SR09 External Signal for activating signal sup-

pression

Alarm CollectiveAlarm Internal Module collective alarm

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Sin comentarios

Jumo 705021 mTRON T - Analog Input Module, 8-Ch. Operat Manual de usuario Pagina 31